1. Despite the greatest care certain
allowances must be reserved at all times for the quality of
materials, the finish etc. On work to scale exact measurements
will be used. Large discrepancies that occur due to shrinkage
or warping of materials will be reserved. For changes
occurring after delivery through outside influences i.e. fair
wear and tear responsibility will only be accepted where these
problems were caused as a direct result of poor workmanship.
In the event of goods being rejected due to material or labour
faults a complimentary replacement shall be supplied. Under no
circumstances will the supplier be liable for consequential
loss or damage. With regard to merchandising guarantee of
supplier will apply.
2. Delivery of artwork or data will be
covered as in 5a) above. The customer must check that all
artwork drill/route files deliver are complete and correct.
Rush Circuit Technologies will not be liable if your order is delayed due to
incomplete file/s or due to delay in receiving your
instructions.
3. On receipt of complaints as agreed the
supplier has the right to correct any damage, offer a
replacement or credit the amount deemed reasonable. Further
claims will be rejected. Replacement goods will be delivered
in a standard lead time.
4. The supplier will not acknowledge
complaints where goods have been altered in any way unless
permission to do so has been received in
writing. |
